-
As of this writing the plugin is able to boot up and put the roller shades into HomeKit, but they don't have accurate state and cannot be controlled. This issue will document work being done to attem…
-
Issue #29 already deals with moving the roller binds to NodeMCU.
When this is done, a couple of buttons needs to be added to the physical board that then sends messages via MQTT to Home Assistant:
…
-
Thank you very much for implementing this project; I came across it after a long research regarding my Weinor blinds...
As described in the instructions, I obtained and soldered a C1101 radio module …
-
Hi,
I don't seem to get my blinds (motor controls) in Home app. (Blinds are working fine through the Niko home app)
Hobby password is OK. The IP is also the correct one of the smarthub.
In the …
-
Hi,
im using the plugin on a synology nas to control lights an blinds, myhomewebserver1 ist installed.
The control of the blinds in the home app is a bit tricky. If i use the slider to, let’s say,…
-
Hello. I have been using your plugin for over a year to control my Somfy blinds and it has been great. You kindly helped me in early January by supporting the MY setting on my RTS blinds which were di…
-
Add button "Stop" to blind control
-
When creating a blinded payment path for an invoice, we should allow the caller to
select the channel they want to receive on. This will allow them to force a sender to
pay over a specific channel …
-
### Prerequisite
- [X] Yes, I've read the readme completely.
### Cache
- [X] Yes, I've cleaned accessory cache and the issue still exists.
### Version
1.6.0
### Device Infomation JSO…
-
OK, here´s another one:
I have two different kinds of wireless switches in my installation, which are single switch sensors only. There is no actuator present. These are not visible in the integrat…