-
I have BTT Octopus Pro 1.1 STM32H723
for 3D printer
and i'd like to try GRBL on it to check laser engraving, and also will be nice to see it in Web Builder.
@Michaels5155 in https://github.com/d…
-
Can anyone help me resolve this error?
Warning! Ignore unknown configuration option `monitor_flags` in section [env]
Warning! `src_filter` configuration option in section [env:include_tree] is dep…
-
Hello,
I've been trying to calibrate my Eddy, using it as endstop and **without the Z-Offset** config.
When the nozzle is touching the bed, Eddy is **2mm** from the bed surface
I ran `LDC_CALIBRA…
-
Hi.
I bought the kit first with CB1, did not notice that the module does not support DSI.
I later purchased the CM4104032 specifically to support the screen.
But when I connect BTT PITFT50 V2.0 - …
-
When using the `buffer` keyword, the code completion suggestions like fields before the buffer names. It would be nice if the buffer name was listed first, then the fields in this situation.
For e…
-
I have a Raspberry Pi Camera v2.1 that I have confirmed works on a Raspberry Pi 4. When I connect it to my BTT Pi 2 however it does not work.
Here are the details of my setup:
Installation image: …
-
### What happened
```
## Expansion ports
# EXP1 header
# EXP1_1=PB5, EXP1_3=PA9, EXP1_5=PA10, EXP1_7=PB8, EXP1_9=,
# EXP1_2=PA15, EXP1_4=, EXP1_6=PB9, EXP1_8=PD6, EXP1_10=,
```
##…
-
**BTT PAD7 , with CB1 board,**
- installed CB1_Debian11_minimal_kernel5.16_20230303 - ok
- installed octoprint - ok
**tried to install octodash,**
can acces remotely, so system operates, ssh -…
-
I compiled marlin firmware on skr mini e3 v3 and the relay when i switch on the relay goes from on to off, then i have to press the reset button then it comes on and stays like that. Is it normal ?
-
Hello,
I am trying to make the TMC5160 vom BTT to work.
I am having the v1.2 and 1.3v of these stepper drivers.
Both do not have any solder pads or jumpers to change their used mode (as far as I …