-
I've been trying to get a BLTouch setup with my Ender 3 and E3 Mini 1.2 board. But the firmware won't load and i get a TMC Connection Error.
What does this actual error mean?
I've tried compilin…
-
Turnkeylinux.org indicates that TKL v16.1 is Odoo 14, while TKL v16.0 is Odoo 12.
However in Hub.Turnkeylinux.org the Install choices are only 16.x and 15.x..
After an install it looks to be 16.0…
-
### Cura Version
5.5.0-beta.1
### Operating System
Windows 10
### Printer
Ultimaker S3
### Reproduction steps
Slice and run a job with prime blob enabled. Then monitor the print progess on the …
-
Only for Neva, Magis and Sigma
-
I allway find myself thinking twice before printing without a computer (i.e. from SD card or from octoprint). The reason for that is that if anything happens it is very slow to react using the LCD and…
-
"set_bed_level_equation_lsq" is doing some bad math
problem im have is X and Y pos
this is giving me a headache.
first here is log data
```
G29 Auto Bed Leveling
setup_for_endstop_move > enable_end…
-
See this https://youtu.be/2It5vxwVnbQ
To answer the two most likely questions. No, the gcode does not contain instructions to go for infinity and beyond a handful of lines into the print. Yes, the …
-
Hello,
I got a stupid question, after my delta executed G28/G29, the result is unsatisfactory, as this situation, should I run G29 again or any other methiod?Thanks
-
Hi Kevin, on my IDEX printer I would like to be able to turn OFF the stepper motor to the X2 axis if not being used (so I can position it manually and utilise the second parts cooling fan for small…
-
At the beginning of a print, just past the first curve of the brim and before it prints a long straight line, I get the error:
```
Move out of range: 163.143 61.316 -0.021 [295.519]
```
I don'…