-
Holding C0135 key "S2" during start-up or reset should set the EEPROM values for Node-ID and baud rate to default values:
* Node-ID in EE_NODE ($4000) to 1 (holding register 0)
* Baud rate in EE_B…
-
The original W1209 firmware has a configurable overheat protection that shuts off the relay when the temp rises above a set value. I'd like to create a similar feature that, rather than shutting off t…
-
Hi Thomas,
I know pretty much next to nothing when it comes to eForth. I did not know what it was until a couple of days ago when I was trying to see if there would be a better firmware for the 4 r…
-
Hi. I have a W1209 with STM8S003F3P6 on board. After the successful flashing I am stuck with the "4th" display. Long pressing "set" has no effect.
I ran
```
make clean
make BOARD=W1209 flash …
-
Hello,
I'm looking for easy way control relay (220V load) with modbus and input pins (push buttons) on C0135 board.
As far as I understand I need to implement modbus and handling push buttons with G…
-
Looks like there are some issues with the 1.3.1 build in singularity. I get a TemplateFlow warning and a bunch of DeprecationWarnings as soon as I submit. The standard output shows that BIDS complianc…
-
Running 2.2.19 (many thanks) on a C0135
300 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 ________________
310 0 20 0 30 3 15 3 17 0 10 3 10 56 78 12 34 _ _4_ _____ Vx_4 ok
.s
123…
-
台北市
http://www.tcc.gov.tw/iFrame.aspx?n=454A3A5A2B5D2DCB
新北市
http://www.ntp.gov.tw/content/contact/contact01.aspx
高雄市
http://www.kcc.gov.tw/PeriodMembers/Contact.aspx
桃園縣
http://www.tycc.gov.tw/pag…