-
Hello @collin80 ,
We are looking for using due_can library for our project, We have Arduino due and we are new to CAN protocol.
We need some clarity on how to use your library .
1. Is there any hardw…
-
Using the set_mask_filter_recv.ino example with CANBUS RP2040 board, I do not see the interrupt callback being fired, despite relaxing the receive filters.
However, if I modify the loop to use the ch…
-
Hi! I have to use your library for communicate with an plc
How can i change the baudrate of canopen?
-
I'm trying to modify the AGCON_B1 example that uses mostly four DHT22 sensors and the general purpose parallel I/O expansion MCP23S17 in order to have a template from where I can start to develop a ne…
-
Compiled Android app just says "Loading" on CM13 OnePlus2
-
Hi,
What is the current status of the code?
I checked out your dph4 branch (since it seemed the most current) and built the DPH-OlcbBasicNode project on an Arduino Uno with a CAN-BUS Shield, as …
-
I have got a setup with a new Kelly KBL Controller and a Arduino Uno with Can Bus shield. Can init() is o.k., but I dont receive any data from the controller!
Any ideas?
Thanks, Thomas!
-
### Board
ESP32 Wroom
### Device Description
ESP32 Wroom V4 Devkit
### Hardware Configuration
GPIO33, GPIO32
### Version
latest development Release Candidate (RC-X)
### IDE Name
PlatformIO
…
-
Hello everyone,
I have a question for you. Can I use SAVVYCAN with CANable? I think ı can do it but ı wonder , Ultimately CANable is a USB to CAN bus converter adapter.
Thanks for helping.
Bes…
-
Hello Markus,
May I ask You, if You know how to read the gear number, lock-up state and gearbox oil temperature from the CAN (preferably through OBDII)?
I am using Jeep WG with this gearbox for ar…