-
Hello, can you add region CN470 band code to the source code?
-
### What version of Go are you using (`go version`)?
$ go version
go version go1.17.6 darwin/amd64
### Does this issue reproduce with the latest release?
Yes
### What operating system…
-
Hello everyone,
Anyone have an error like the one below
`LMIC-node
Device-id: nodemcu-32s
LMIC library: MCCI
Activation: OTAA
Interval: 60 seconds
FAILURE
.pio/libdeps/nodemcu…
-
I am trying to use the MCCI boards but cannot find a board similar enough among the ones available. Specifically, in the current platformio library there are no STM32L0 boards with Arduino framework s…
-
## Issue Description
The following semantic models are not referenced in the individual standards of the standards repository:
## URL to Model with Issue
"io.catenax.material_demand:1.0.0",
…
-
1) I'm using a 4460, but need to add an I2C device at addr: 0x50 where the Fram is located...
I see the FRAM8K driver and it has its address defined in the Mb85rc64ta.h file, so I can change it there…
-
The library worked fine on Arduino 1.0.6, but after upgrading to v2.0.0 the device reboots on the next loop cycle after calling `Arduino_LoRaWAN::SendBuffer()`. I have a `Lora` wrapper class which sim…
-
## Link to Standards Document
Standardization Document is not yet available in [library](https://catena-x.net/de/standard-library) but went through standardization.
Number; CX-0085
## MS1 Crite…
-
I need to implement a LoRaWAN device that sends a message every 10 minutes. To limit the power consumption I need to put the device to sleep between sending the messages.
If I use ABP, the problem ca…
-
### Discussed in https://github.com/mcci-catena/arduino-lmic/discussions/832
Originally posted by **zl3ag** December 18, 2021
This library is being used globally by lots of different apps.
…
zl3ag updated
2 years ago