-
I'm using a Radxa CM3 module on a Raspberry Pi CM4 IO Board.
I built the image as described, and flashed it onto the internal eMMC.
The board starts U-Boot SPL, but then hangs after verifying the ch…
-
What is the new model compatibility information for the new CM3+?
Do we need to update any os.json files? Or is it compatible with the existing CM3 model?
-
1. Current variable list requires an option to edit the units of existing variables.
- Database format : "volumetric water content (cm3/cm3), rainfall sum (mm/day)
- ISMN format : "soil moisture…
PR-HL updated
3 months ago
-
I built the library on Debian Bullseye OS on a Radxa CM3 board, and everything goes well but when I tried to set an interrupt on any GPIO using `mraa-monitor`, the pin value always returns -1. I tried…
-
I have a Virpil CM3 throttle and set the idle cutoff in launcher settings, enabling cutoff in BMS config as well. However, it doesn't apply in game, I cannot go in and out of idle.
![image](https:…
-
I installed RPIO (branch v2) on an ACME System CM3-panel board running the last Raspbian Lite available.
As per the name, this card is powered by a CM3 module (lite).
Running the rpio --sysinfo, I …
-
The image boot check, e.g.[1] ignores the exception and the process output.
It would be nice to get result in case of exception, as I am encountering a situation where the machine is booted and I ca…
-
I tried to flash my risinghf outdoor miner with CM3, it looks like it was flash ok, but it does not boot. When I re-flash it to the original firmware, it works. Since I find nebra firmware much better…
-
### Your name
Joe Palmo
### Your affiliation
MIT
### What happened? What did you expect to happen?
The planeflight diagnostic output I am getting for furan is confusing. I am seeing significantly…
-
Self note: (please ignore, it's just so i can keep track of issues myself)
Add /cmob dmg -> changes mob dmg (lookup if possible...)
Add /cmob aggressive ( ??) -> makes a normally non-aggressive m…