-
Hi Peter,
by any chance, do you have any advise how to proceed in case of demand ventilation (Brink Flair 325 + Zone Valve + Air Control)? I replaced Air Control with eBUS Adapter Shield v5 and I w…
-
Would it be possible to add "state_class: measurement" for sensors defined in "platform: ebus"?
```
sensor:
- platform: ebus
sensors:
- name: "Boiler Supply Line"
circuit: …
-
Hi i have a Vaillant turboTec without controller. I am using RPi + ebusd to control my boiler, currenterror, HeatingSwith, SetModeOverride and others are working well. But I cannot find how to clear t…
-
Hallo,
gibst du den Source für die ebus.h nicht frei?
MfG Lutz
-
Hi
I'm trying to get the adapter to work with Weishaupt WRSol 1.1
I've adjusted PWM value until the LED starts blinking ( also checked -/+ 1 which lead to steady off or steady on ). But when I f…
fatz updated
3 months ago
-
My installation:
Vaillant AroTherm+ 105/6, VWZ AI (only 1 temp sensor + ebus), Thermostat VRC 720f, VR912 (sensonet gateway). Ebusd is connecting to the ebus interface over WiFi, powered by an ipa…
-
Hi,
I'm trying to figure out if it's possible to have some basic authentication configured, so that I can prevent random people on my network from being able to connect to the adapter with ebusd an…
dulek updated
5 months ago
-
Hi!
First of all I would like to thank you for publishing these configuration files, as they helped me a lot getting ebusd configured for my Brink HRU unit.
While doing so I noticed that my se…
-
I've got an Ochsner GMLW 19 with TEM-Controller connected to with john's ebus adapter.
ebusctl find:
.
address 15: slave #2, scanned "MF=TEM;ID=24849;SW=0604;HW=0102"
.
I'm using 15.24849.HW01…
-
## Describe the issue briefly
Almost all the physics ebuses are gone or not exposed to Lua and in their place are new classes and functionality that is not well documented and one of the most impor…