-
Currently using my fork https://github.com/jonlamb-gh/enc28j60
Finish up https://github.com/jonlamb-gh/enc28j60/tree/embassy-fork
See #19
-
Hi
I have a NODEMCU ESP8266 and an ENC28J60 Ethernet Module.
I've been able to successfully flash the Firmware by making the Changes in user_config.h and enabled HAVEENC28J60. I have a project whe…
-
Hi, I'm trying to use the websocketServer example with a esp8266 and an enc28j60, but I'm not able to connect to it, the code I have and the following:
```cpp
/*
WebSocketServer.ino
*/
#define …
-
I tested your code and enc28j60 is successfully linked up, but the code keep restarting itself roughly every second.
```
ets Jan 8 2013,rst cause:4, boot mode:(1,7)
wdt reset
user_main.c:u…
-
I'm trying to make ENC28J60 work with NodeMCU. I followed the connection instructions and I'm using the 2N3905 transistor for decoupling GPIO15 along with 3.3k resistor. NodeMCU boots fine but from Se…
-
"The library cannot currently be used with hardware based on the ENC28J60 chip – such as the Nanode or the Nuelectronics Ethernet Shield. For those, there is an alternative library available."
Pubs…
-
Hi ..
I would like to use your library instead that with the wifi network using an ethernet cable.
The Ethernet shield is Enc28J60...
Can you provide some code examples about where modify and wh…
-
Enc28J60-based shields are few dollars cheaper and are widely spread.
Edit [stubs](https://github.com/4ntoine/ArduinoCommander-ethernet/tree/master/Ethernet) to add Enc28J60 support.
Uncomment `//#i…
-
Hi... I am trying this example to use your library with ESP32 and ENC28J60 shield.
``
#include
#include
// Enter a MAC address and IP address for your controller below.
// The IP address wi…
-
// Reset the transmit logic problem. See Rev. B7 Silicon Errata issues 12 and 13
writeOp(ENC28J60_BIT_FIELD_SET, ECON1, ECON1_TXRST);
writeOp(ENC28J60_BIT_FIELD_CLR, ECON1, ECON1_TXRST);
write…