-
Since the board fan is active only when stepper_x and stepper_y are active, on idle the SOC gets quite warm.
macOS
### OS Version
15.0.1
##…
-
fan2go is unable to set the fan speed on my system
fancontrol and coolercontrol can do so just fine, enabling the corresponding services one-at-a-time.
But when I do `sudo systemctl start fan2go`,…
-
When using either of the API points, the response is "get_fans" rather than fan speeds or presets
curl http:///ilo-fans-controller/index.php?api=fans
get_fans
curl http:///ilo-fans-controller/ind…
-
I run an automation every 5 minutes to update normal fan speeds (Nibe F470) on external factors.
Does not fail all the time so not cricital, but quite a few times this pops up in the logs of HomeAs…
-
### Laptop model
Alpha 17 B5eek
### EC firmware version
17LLEMS1.106
### Description
**Tl;dr**
cpu-fan-speed: seems incorrect
gpu-fan-speed: plausible, but somehow not in "turbine mod…
-
### Printer model
MK4
### Describe the enhancement
If my gcode uses layer-time dependent cooling or dynamic cooling, the gcode constant overrides my manual print fan speed changes. If there was the…
-
### Application [Required]
Intel Arc Control
### Processor / Processor Number [Required]
Amd 7800x3d
### Graphic Card [Required]
Intel Arc 750
### Rendering API [Required]
- [ ] Vulkan
- [ ] Op…
-
### The problem
Adding device "Fireplace + Blower Remote SH4001D" to Tuya integration only creates switch entity to turn fireplace on/off but does not include BLOWER FAN SPEED which is available in i…