-
Bug: `prange` does not lead to good parallelization.
The following example runs an expensive function 100 times.
* The serial implementation takes **0.39 seconds**.
* A parallelized implementation …
99991 updated
3 years ago
-
Simple code included to demonstrate.
Connecting to the wifi on power up (or wake from deep sleep) is slower when using wifimanager.
The demo sketch takes about 5 second to print the IP address and…
-
Using [wESP32](https://wesp32.com/) (wired ethernet port) with 1.8.10 Arduino IDE and ESP32 SDK 3.2.3, the ethernet portion seems to fail. This may be related to #56 or #52, as DNS never seems to get …
-
I am probably missing something very basic here but when trying to migrate to mainline I am running into a roadblock when trying to get klipper on the mcu's. I'm following step by step very carefully …
-
**Describe the bug**
SmuView can't connect to either my DMM (Brymen BM869s, connected via BM-86X), nor my PSU (RND 320-KA3005P, connected via USB). Both are detected by sigrok-cli (0.8.0-git-525f481)…
-
Someone else has had a similar issue here:
https://youtu.be/4z5OOW1jL94
I’m also using an M1 Mac.
I’m also reverse engineering the vendor .net binaries to attempt to figure out what is going …
-
**Describe the bug**
Adding a new IT8511A+ device results in segmentation fault
**To Reproduce**
Steps to reproduce the behavior:
1. Go to 'Add device'
2. Pick ITECH IT8500 driver
3. Selec…
-
Hi,
I had an long print on a printer. It should have runned for 5,5 hours but in the morning the print wasn't finished and was stalled.
After some investigation we found out that it wasn't a mem…
-
Hi,
I was thinking of a scenario, where micro:bit runs off battery and does some activity tracking every now and then. The battery may or may not have on-off switch and the user might forget to turn …
-
**Update:** If you are using an unmanaged Mac and run across this issue, the following commands *may* fix this issue:
```
/usr/libexec/ApplicationFirewall/socketfilterfw --add /usr/libexec/bootpd
/…