-
### Expected Behavior
I have a single 12S2P 6,85kWh module with ~44V out of a VW.ID3 battery pack connected with a Daly smart BMS supporting CAN/RS485 etc. How a single battery module from the resp…
-
Hi,
When trying out the programme for the first time using a Fronius inverter+smart meter I received the following error message:
"Modbus Error: [Connection] Modbus TcpClient(192.168....): Connecti…
-
Since you support the BYD BMS, is it possible to add BYD CAN protocol as the output? I'm looking to make a custom JK BMS battery to use with a Fronius inverter, they support BYD batteries CAN protocol…
-
In my case, batcontrol wants to recharge only 2.4 Wh and sets a charge rate of 3 Watts.
That 3 Watts is more likely a "keep you current SOC%" energy rate.
```
2024-11-25 06:21:01 DEBUG [FC Con…
MaStr updated
3 hours ago
-
If the task fails to connect to the API there is a rather large dump. Seems excessive...
```
ERROR:server.tasks.srcfulAPICallTask:Error in SrcfulAPICallTask HTTPSConnectionPool(host='api.srcful.de…
-
System was reaching its lower bound (notstrom dose) with 7% and stopped using the batt…
-
Hi,
the Fronius SolarAPI delivers the status if the house is on grid mode or backup mode.
You can query this via the SolarAPI, see doc below.
It would be great if I could manage my power consum…
-
I currently use the built in Fronius integration and it works well.
Occasionally though there may be an issue with something in the chain and my HA data is lost.
Examples are, Fronius data logger lo…
-
After installing the `node-red-contrib-fronius-solar` palette v1.0.4 I cannot see the `inverter` node. The `control in` node is there.
 zusätzlichen Use Case:
Der Fronius WattPilot dürfte die AC-Ströme die vom SmartMeter übermittelt werden für das Load Balancing verw…