-
The super chlorinate button is not working. It will attempt to enable superchlorinate mode but doesn't fully do so. The pentair app has the super chlorinate turned on but the ichlor doesn't light up a…
-
**Updated at the bottom of this post. I think I have figured out my answers, but just want to be sure and get another set of eyes on my setup. I only have an AquaRite Chlorinator at this time.**
I…
-
**Describe the bug**
VS 3050 pump is read as VF. GPM are not reported, but watts are.
**To Reproduce**
Just shows up on home screen.
**Expected behavior**
I would expect to see VS with RPM
…
-
When I create a schedule and save it, I get a popup Error:InvalidEquipmentData with the following stack trace:
ApiError: Invalid heat source: null
at ScheduleCommands.setScheduleAsync (/home/p…
-
Have the pi connected directly to the Aquarite. Have separate 12v power and ground applied to the Aquarite. Tried two different RS-485 adaptors, and have reversed the wires.
[replay (9).zip](https:/…
-
I have the iChlor connected to intelliconnect. With intelliconnect I can see the water temp, so I tried to figure out where this data was coming from. Here is what I found
`10 0210 1600 0f49 000…
-
**Describe the bug**
After restarting the controller when it is shut down unexpectedly (pm2 stop or crash), it is no longer able to control the pump.
**To Reproduce**
Steps to reproduce the behav…
-
loaded up version 6 went very well -- but neither of my heaters show up in the states array:
![image](https://user-images.githubusercontent.com/4008317/88595413-8103ca80-d028-11ea-968f-06fdd0d77e8…
-
Hi, I'm using version 5.3.1. I have a Pentair VS and iChlor 40 with no controller. Using the virtual pump controller, I've noticed that the pump display continuously toggles from enabled to disabled a…
-
Here is the packet capture from my intelliconnect. I have an intellipro vsf pump, the ichor 30 swg, and intellibrite 5g color lights. The intelliconnect phone interface is very slow, 5-30 secs betwe…