-
I tried to compile the package in Windows 10 (64-bits) under MSYS2 and encountered the following errors:
1. `printenv` gave me "Windows_NT" instead of "WINDOWS", so I had to change that.
2. then t…
-
I have a couple of Teensy 4.1 microcontroller units. They are supported by the Arduino IDE. Specs:
Teensy 4.1 Specs
* 600 MHz Cortex-M7 processor (NXP iMXRT1062) ...
* 8192 kB flash memory (64 …
-
I have spare input in esp32 board. can I use lathe mode with esp32 if yes then kindly inform me how to set gpio pin for spindle encoder.
I am using 1.5 kw servo as a spindle which can do both operati…
-
## Issue template
- Hardware description: Teensy 4.1, Arduino 2.2.1, Teenseyduino 1.58.1
- Installation type: Humble (reinstalled today)
- Version or commit hash:
#### Steps to reproduce the …
-
I've been mulling this over for awhile now, and really I'm starting to think...
We should have a HAL crate per chip, that depends on a common HAL (imxrt-hal) still.
My reasoning really comes bac…
-
### Describe the problem
Suppose I have the Teensy board types installed, like 1.58.1, and I did a few builds, and then decide I wish to try something out on the current beta build 0.59.2. Run a te…
-
Hi,
first of all thank you for the great work.
So, I was trying to compile the Aurora example using a Teensy 4.0 and Smartmatrix Shield V5 but I get an error message in line 400:
Arduino: …
-
Hi,
This project looks amazing. However, on trying to build, I get the following errors:
> Executing task: platformio run <
Processing teensy40 (platform: teensy; framework: arduino; board: t…
-
What would it take to support the Teensy series of chips - especially the newer 3.x and 4.x families based on Cortex M families?
- Teensy 4.0 and 4.1: "an ARM Cortex-M7 processor at 600 MHz, with a…
-
## Steps to Reproduce(ubuntu)
1.apt install gcc-arm-none-eabi
2. ./autogen.sh
3. ./configure --host-arm-none-eabi --target=arm
```
hecking build system type... x86_64-pc-linux-gnu
chec…