-
Would it be possible to integrate support for standard linux hwmon that can monitor power of the system? I am running a small system (baseboard: [CM4-POE-UPS-BASE](http://www.waveshare.com/wiki/CM4-PO…
jviki updated
3 months ago
-
Hello,
I built up everything on a breadboard and run all components on 3.3 V. The display shows the initial values as long as only the ATtiny85 is attached to it. As soon as I connect the INA219 th…
-
**Describe the bug**
I have a small circuit involving INA219. At this point, during experimentation it looks the same as an example at https://github.com/dotnet/iot/blob/ca63c979bd8fd9c47acff379f09…
-
When installing software I am getting this error. I have reported it at ina219 library, yet they point back to the board itself.
https://github.com/chrisb2/pi_ina219/issues/32
pi@piraspberry:~/u…
-
i tried to make it, using esp8266 with l298n driver and ina219. but i found powertrip problem. Please help me sir, what's wrong?
-
### The problem
This is a bi-directional device.
A negative current and a positive voltage should produce a negative power (P = I x V).
However the power reported by ESPHome is always positive…
-
Hallo,
ich habe gerade ein Projekt wo ich die Anbindung des o.g. Sensors verwenden könnte.
Ist denn die Einbindung des INA219 noch geplant?
Viele Grüße
Elmar
-
Hi, I have Waveshare UPS HAT (D) and I have installed the latest version of this integration (downloaded from the master branch) in HA.
Using the `INA219.py` script from Waveshare, I'm getting prop…
-
Hello,
Is this library for the INA226 ?
I have been taking a look at your configuration functions, specifically the mask used conjointly with register addresses. The register addresses are correc…
-
The reading from my INA219 off by about 0.3v compared to when I read voltage with a multimeter across the battery + and -.
I've got the VIN- connected to + terminal of the battery [according to thi…