-
```
#!watchflakes
default
-
Hi, I would like to primarily use the device for receiving signals from my IR remote control.
I've been reading in the documentation that "The same feature will soon be available for the infrared rec…
-
Hi,
I found that if I call IR emitter then call RF emitter, when it emits RF, at the same time, the last IR will be emitted as well.
Can you help to check?
Commands & Results below.
Thanks…
-
Hello,
your sensor is working very well with my FHEM :-)
Sending and receiving is is working stable.
But after sending an IR signal i need to reset the Nano by hand to receive again.
-
Ubo Pod comes with hardware support for sending and receiving Infra Red commands. Pod has 4 IR LEDs that blast IR light at 4 different directions. It also comes with one front IR receiver.
The rec…
-
```
#!watchflakes
default cp go.mod.new go.mod
> go get rsc.io/needgo121 rsc.io/needgo122 rsc.io/needgo123 rsc.io/needall
[stderr]
go: downloading rsc.io/needgo121…
-
Sorry for a maybe dumb question, but I don't understand the generated signal.
When I start the ESP32 the signal on my chosen GPIO is LOW. With the first sent signal it flips to HIGH (s. attached pict…
-
**Describe the solution you'd like**
```yaml
fan:
# other stuff
availability_sensor: sensor.ir_bridge_status
```
OR
```yaml
fan:
# other stuff
availability_template: "{{ is_state…
-
```
#!watchflakes
default cp go.mod go.mod.orig
# 'go mod tidy' without -e should fail without modifying go.mod,
# because it cannot resolve x, y, and z simultaneously. (0.043…
-
In transmitter.md you have mentioned about two push buttons. Is that each of them is for sending different signal? How should we connect it?
I have a requirement of waking up the philips tv from stan…