-
Main Issue:
The board won't properly boot up after code is successfully flashed.
It appears to me that the code can't fully load, and isn't even getting as far as void setup !
-----------------…
-
Hi,
I got the tally light working on several M5Stack modules (Core, Core2 and StickC Plus, all ESP32). All using WiFi to connect to the Atem.
In some situations however, the Wifi signal is unrel…
-
Hello,
The M5Stack Core 2 LCD is not working (The screen left off)
Do you have any documentation or update for this model ?
Thank you.
-
### Describe the bug
The m5stack board definitions are based on arduino-esp32 2.x but I want some newer wifi stuff so I tried building with the now upstream arduino-esp32 m5paper board target and i…
-
@kevinl95 I purchased a new M5Stack CoreInk device, downloaded the code, and tried to compile it with no success..
The code generates some warnings, but I assume the sketch will compile even with …
-
### The problem
Defining "framework: type: esp-idf " with the POESP32 makes it not boot on POE
When the "framework" is not defined the device boots on POE just fine but then doesnt work as BL…
-
**UPDATE:**: Use the following command line to build on MacOSX:
```sh
CRATE_CC_NO_DEFAULTS=1 cargo build
```
================
## Bug description
Build fail when build new project from `esp-…
-
M5stack issued
https://shop.m5stack.com/products/m5stack-coremp135-w-stm32mp135d
It’s actually not a microcontroller. It’s a 512MB RAM Linux computer with Debian Linux, two CAN bus interfaces, …
-
Hi there,
I am using a M5Stack Gray with ESP32 core on flow web IDE. The connection and firmware installation were successful.
Due to the aim of my project, I need some third-party libraries, s…
-
Hi felmue
I have another question concerning the OTA update speed. What are your experiences regarding the transfer rate of the SIM7600 module? For me, it is incredibly slow at 2kB/sec. A 1MB downl…