-
**Describe the bug**
Does not heat as expected.
Brand new just unpacked miniware TS100 device. On the stock 2.20 firmware it heats well.
**To Reproduce**
1. Plug the power, screen shows value …
-
I've built 3 tips with thermocouples hard-soldered/brazed to the end (670C melting point): https://youtu.be/oAAN9YCJlkc
I've got a miniware D24, a generic B2 tip and a Hakko T15-D2.
Here's my "l…
-
What about supporting MHP30 ? From the feature side it is very similar to ts80p. Externally it is basically the same iron (A B buttons, one OLED screen, type c pd and hotplate_vs_tip ), just in hotpla…
-
**Describe the bug**
I'm getting weird standby temperature readings on my TS100, off by 100+°C.
What's event weirder is that the temperature reading varies considerably based on the input voltag…
-
Hello,
I love this firmware and have been using it for years now. Thanks for your work! After starting to make use of a soldering stand, an idea came to me that might, or might not be worth the eff…
haarp updated
2 years ago
-
Hello, I bought a ts100 and it worked, but I decided to update the firmware and then it did not run anymore and when I connect it to the computer I do not get the config folder, can it not be included…
-
-
my setup:
original pinecil v2 (tried 3 different)
firmware (3 different): 2.20 stock , 2.20 release and 2.21 release
original pine64 original short cartridge (tried 3 different)
cable tr…
-
Hello, I have the ts80 and after version 2.10 it is getting stuck on 5 volts although I have it on 9v or 12v. To unstuck it, I have to pull the USB off the power source. Sometimes it is stuck on 5v tw…
-
Hello,
I modified the hello_can example to use CAN-FD and encountered a bug where `fd_data` contains the frame flags and the DLC. I am not 100% sure I am using the CAN-FD driver properly, so please…