-
A 31-ET synth written in SuperCollider, controllable by a monome.
https://github.com/JeffreyBenjaminBrown/monome
31 ET is hard to play on a linear grid like a piano, as your hand can only reach ac…
-
- [x] do not send LED data when no focus
- [x] clear and update LEDs on focus
-
Hi. You are doing a very good moving this classic, important module forward! Thank you for that.
Am I imagining things, but does the *MIDIout* app tend to choke, and stop sending stuff after a while?…
-
PR https://github.com/monome/norns/pull/1740, which fixes Link clock to start on beat 0, uses negative beat values during the count-in. This works great but `clock.sync()` does not resume coroutines o…
-
Hey! 1st off, thanks for writing an awesome bit of code to make the untz' play nice w/ the monome software in max -- great, readable code, clearly legible, a huge THANK YOU. It's been super frustrat…
-
recent linux install requires python-pipx rather than python-pip3 --- checking macos now
simple doc update
tehn updated
3 months ago
-
according to the spec as i understand it, the bulk-update commands that operate on 8x8 blocks can pass along x,y offsets that aren't actually multiples of 8. Right now, untz_monome will break if it s…
-
'hz' and 'ratio' parameters are both 16.16 values.
the phase increment for each oscillator is calculated by multiplying base hz and tuning ratio to get final frequency:
https://github.com/monome…
-
The [monome protocol](https://monome.org/docs/serialosc/serial.txt) specifies that messages for LED rows, columns, and maps target a "quad", i.e. an 8x8 segment with an x/y offset. The webmonome API r…
-
In some cases USB soundcards get ALSA card ID 0, which is the one we use to run JACK. This means sound is going to the wrong soundcard, or in some cases (MIDI devices without audio) JACK is unable to …