-
### The problem
The integration data is delayed and doesn't update after a certain point. In this situation, the charge level is stuck at 99% while I unplugged the USB and attached the PC with Pow…
-
### The problem
Since I purchased UPS BX750MI, after few days it duplicates itself losing all the automations.
Same as #95016.
When I unplug the main power from the UPS, the device gets duplicate…
-
````
...
0.007398 [D2] Entering run_snmp for 1 IP address range(s)
0.007411 [D1] nutscan_scan_ip_range_snmp: Scanning SNMP for IP address range(s): (1)[10.94.56.0 .. 10.94.56.255]
0.007774…
-
On an APC SMT1500C device using the rtu_usb version of libmodbus and a USB cable, reads fail with a timeout.
Since support for USB based APC Modbus is not mainlined, I am building the required RTU_…
-
As slightly noted in issue #2575 and in PRs that dealt with parallelized scans in `nut-scanner`, depending on platform defaults and particular OS deployment and third-party library specifics, `nut-sca…
-
MacOS Ventura | NUT v. 2.8.2 from MacPorts
When trying to run ```sudo nut-scanner -DDDDDD -C > /tmp/nutscan.log 2>&1``` on MacOS Ventura (installed via macports) I get the following output:
```
…
-
It would be useful if WinNUT could attempt to reconnect to the NUT server indefinitely. This would mean that it is quieter about the reconnection attempts. If the tools are available, then it may also…
-
Hello,
I'm trying to configure NUT on proxmox using the following link (https://www.kreaweb.be/diy-home-server-2021-software-proxmox-ups/) but when i use the command "nut-scanner -U" it doesnt rep…
-
Primarily *mea culpa* about earlier commits as I was learning this corner of the NUT ecosystem and amassing DDL info from github issues and mailing list posts.
Also check about "Source:" and "Vendo…
-
Hi,
A week ago I setup NUT Server on a Raspberry Pi 3 connected with USB to **Powerwalker VFI 1500 RMG PF1** UPS.
`nut-scanner` detected it like
```
[powerwalker]
driver = "nutdrv_qx"…