-
Hello,
Could you please provide more details on how to write firmware to the internal flash drive? I've successfully run your firmware from the SD Card and now want to transfer it to the QSPI flash…
-
I follow the instructions to build the project on Ubuntu 20.04. Then create "gpssim.bin" and try to transmit to Pluto SDR via "plutoplayer".
Command lines are shown as:
`./gps-sdr-sim -e brdc0360.23…
-
Hi @mhennerich @tfcollins
I have a similar problem to the one in this thread. When i tried to use an external GPS clock with 40MHz output, and injected it to the pluto's CLK_IN and changed the xo…
-
Hello,
Thank you for sharing this with the community.
I have compiled gpssim and generate binary file successfully.
But when I try to compile plutoplayer.c in windows, I could not manage to bu…
-
Hi
I was installing leansdr and I included the binaries for libiio and the make step went through.
But when I do make embedded I get the following error.
$ make embedded
g++ -O3 -I.. -DVERSION…
ghost updated
4 years ago
-
Hello,
I have both PlutoSDR and BladeRF. I wanted to upload your Github code as in the descriptions and run it over SDR. With PlutoSDR your code worked just fine, but not with BladeRF. The reason for…
-
Do you plan to add timestamping support to plutoSDR FW?
-
@jocover I added PlutoSDR to my windows installer, but theres some issue with PlutoSDR when a device is not present, because it causes issues for people without a pluto sdr:
This is the problem cod…
-
Hi,
I have a Raspberry Pi 4 B which requires some dependencies not stated in the installation guide - specifically BladeRF, AAudio, RFNM, RDLPlay, and some others. I didn't know if there is an assu…
-
I'm trying to get coordinates with GNSS-SDR (next branch) and PlutoSDR as source of signal. But there is always Loss of lock in channel after few Seconds.
I'm using below Configuration file for Plu…