-
Hi I was wondering if you would be willing to add support for the Airtouch 2 +?
https://www.polyaire.com.au/products/control-systems/airtouch-2-plus/
I have the API but it is a bit beyond me.
-
I attach the Air Touch 5 communication protocol document. To me it looks like the bulk of the codes are the same with some differences in the sub type (zone control, zone status etc). Hopefully, this …
-
After a reboot of home assistant the integration has an error stating it is unable to contact the AirTouch controller. Disabling and re-enabling the integration resolves the issue.
Have looked at t…
-
Hi Mike,
I'm looking at writing something for interacting with my AirTouch2. I've been looking at your code and I'm curious about the protocol as I think the command messages you are sending for AT…
-
Hi there!
Firstly - amazing reverse engineering effort. My congratulations.
Secondly - any idea what part of the protocol handles the zone-based temperature setting (as opposed to the current '…
-
Hi,
Thanks for creating this, I've wanted to connect to my unit for a long time!
I installed the plugin and used the configuration below. I have a Daikin unit with 3 temp sensors in different room…
-
Hi,
Is it possible to get the zone names from the AT4 and present them in homekit instead of Zone 0, Zone 1...
I managed to pull the settings/config information from my AT4 by sending:
`55 55 80 b0…