-
**Describe the bug**
`pxt deploy` reports `Error: cannot find any drives to deploy to` even though the micro:bit is connected and working well in MakeCode online.
**To Reproduce**
Steps to reproduce …
-
I have two splits using teensy's and TRRS jacks correctly sending key strokes across the wire. However, I haven't been able to get an RGB strip to light when connected to the I2C pins. It works when c…
-
![Uploading ard-promicro-5v.jpg…]()
-
I try connect this board with arduino micro pro.
I use next conection https://keycapsss.com/media/pdf/c4/fa/cc/kycs-pmw3360-help-sheet.pdf
RS --- (NONE)
GD --- GND
MT --- Pin_7
SS --- Pin…
-
I think it should be a recommendation to use a micro pro with a USB-C connector. I have broken more micro USB off these than I care to mention 🙈
-
Hello, I am currently using the RP2040 Pro Micro module. After uploading the firmware to the left keyboard, it always stays in the bootloader and cannot load the firmware properly. The right keyboard'…
-
```
Hi, i bought a pro micro version of arduino. This version do not come with A4
and A5.. just came with A0 /A1 /A2 / A3. How can i use a OLED display( with
four pins -> VCC(ok), GND(ok), SCL(?), …
-
```
Hi, i bought a pro micro version of arduino. This version do not come with A4
and A5.. just came with A0 /A1 /A2 / A3. How can i use a OLED display( with
four pins -> VCC(ok), GND(ok), SCL(?), …
-
```
Hi, i bought a pro micro version of arduino. This version do not come with A4
and A5.. just came with A0 /A1 /A2 / A3. How can i use a OLED display( with
four pins -> VCC(ok), GND(ok), SCL(?), …
-
```
Hi, i bought a pro micro version of arduino. This version do not come with A4
and A5.. just came with A0 /A1 /A2 / A3. How can i use a OLED display( with
four pins -> VCC(ok), GND(ok), SCL(?), …