-
Can we port this to the latest version of Marlin?
-
The firmware of my printer (Renkforce RF2000) is based on Repetier.
It supports bed scanning and can output the bed matrix like this using the GCODE command `M3013`.
See also https://www.rf1000.de/w…
-
Hi there
I did create the sh script in config/... and configured it the way it works for me.
Allthough when setting up the MQTT node in Node Red an attach a debug node to it not Output is sent from…
-
Maybe there is a way? I'm not familiar around the marlin codebase.
-
Hello,
_(Again I am not using the original repetier firmware but fixing my old branded Renkforce/Conrad version. Thus my problems could just be my problem - but also be a good hint for original rep…
-
**Describe the bug**
The support material is not printed for the first layer and as a result the support is printed in the air.
**To Reproduce**
Steps to reproduce the behavior:
1. Upload the mo…
-
### Needed Components
RF Transmitter and Receiver like the following:
433 MHz switchable Outlets with remote control
[Renkforce 433 MHz Switch](https://github.com/user-attachments/files/1558635…
-
-
> [!TIP]
> Please also see [Troubleshooting](https://github.com/KIMB-technologies/Radio-API/blob/master/Setup.md#troubleshooting).
**Radio-API Installation**
- Version of Radio-API: 2.9.2
- Inst…
-
For problem with the Beta firmware 22 August 2021: jump to the post below from sumerland
---
Original post but it turned out, Last OTA doesn't mean that the last time the sensor has been updated …