-
I found out that my controller lives at address 17; not 1 which is typical for renogy controllers.
SP410 updated
5 months ago
-
I’m completely off grid and use Macs, Raspberry Pis and Arduinos for a variety of things. One of them is controlling my solar powered well pump located about 1,500 feet downhill from my cabin. I don’t…
-
There are several things that are currently constants within the project.
It would be helpful to allow folks the ability to easily override these things via environment variables and/or a solarshed…
-
I used your info to successfully connect an Arduino MKR1010 to a Renogy Wanderer 10A (model # RNG-CTRL-WND10) charge controller. The MKR1010 natively has Serial1 on pins 13 (RX) and 14 (TX).
In the…
-
Not an issue but a testimony that I was able to pull data from a Renogy Rover Elite 40 using a modified copy of the Wanderer script (my modbus address was 16) Also made a splitter to use the BT-2 alo…
-
Renogy has a series of [MPTT solar charge controllers](https://www.renogy.com/wanderer-10a-pwm-charge-controller/).
They have an RS232 port that one can hook up a bluetooth module to: the [BT-1](http…
rb2k updated
11 months ago
-
Hi,
I have three 40A Rover Charge Controllers that are connected using the Renogy communication hub to an Orange Pi with a USB to RS485 converter. They have slave addresses 16, 17, & 18. I'm pollin…
-
Hi,
I'm slowly doing research into your project to figure out if it'd be worth it for me to get the extra data that'd be possible if I wasn't going through the RS232 DB9 port on the Mate2.
Two y…
-
Here a copy of my error log
2024-09-02 09:56:18.065 ERROR (MainThread) [homeassistant.config_entries] Error setting up entry Renogy Rover for renogy_rover
Traceback (most recent call last):
Fil…
-
Hi,
i would like to install this and enable a Grafana Dashboard for it.
Can you support me ?
Regards