-
Hello again :)
This problem is not a real problem for normal firmware operation, but could be of interest to you.
_Again: I am working with some very old version of Conrad Electronics RFx000 Print…
-
The firmware of my printer (Renkforce RF2000) is based on Repetier.
It supports bed scanning and can output the bed matrix like this using the GCODE command `M3013`.
See also https://www.rf1000.de/w…
-
Hello,
_(Again I am not using the original repetier firmware but fixing my old branded Renkforce/Conrad version. Thus my problems could just be my problem - but also be a good hint for original rep…
-
I noticed this issue on v.1.2.7, too, but nevert reported it.
a) When using pillars as the support pattern, Slic3r will occasionally create the inverted pyramid portions of the support without the pil…
-
Hello All,
Thank you and John Silvia for the great piece of software. I am finally printing with a 32-bit CPU. While setting up, I noticed I was not able to calibrate extrusion - it was inconsiste…
-
### Description of the bug
My research has shown that most (or all?) slicers calculate the extrusion amount incorrectly at corners. See also this same issue under Slic3r ([https://github.com/slic3r/…
-
This will probably end up as a feature request, as it seems all slicers have been living with this issue 'forever'. It just seems that no one has noticed it until now.
**Describe the bug**
I beli…
-
Wieder gabs Ärger damit.
Wir sollten das rausschmeißen...
-
Ich verstehe seit kurzem das Ergebnis des Z-Offset-Scans nicht mehr. Erstmal behauptet er immer, "Z-Skrew too low". Die Ziel-Position der Schraube scheint außerhalb des gültigen Bereichs zu liegen, we…
-
I am in the process of writing the support for my 3D printer (Renkforce RF1000) which has a special type of bed level probes based on a load cell to measure the force when the nozzle touches the build…