-
The RFM12/69 modules can be configured in OOK mode and thus operated like a stupid receiver module on the Arduino Nano. An example could be the reception of FS20 signals in Ethersex (https://github.co…
-
Needs:
- Feather M0 RFM69 LoRa 900 MHz Board
- RFM69 LoRa 900 MHz Pi Bonnet
- Raspberry Pi 3 B+
- 2X SD cards
I should ask Paul first and then go to startup funds.
-
**Hi, I'm trying to get a RFM69HCW radio from HopeRF working as a trasmitter in the following environment:**
Raspberry Pi 2 Model B (raspbian jessie, release from 2016-03-18)
node --version = v4.4.2
…
ghost updated
5 years ago
-
Say a radio is in listen mode, and then a new sketch that doesn't use listen mode is uploaded to the Moteino (e.g. via the Arduino IDE). When the new sketch runs ```RFM69::initialize(...)``` the radio…
-
The basic sensor board should be designed based on a 70x90mm (26x31) perfboard. The board should contain the Blue Pill STM32 board, the RFM69 connector and a button. A I2C or analog sensor will be add…
-
RFM12 modules are getting more difficult to find.
Basing this project on a RFM69 module used in RFM12-compatible mode would be preferred.
Porting the whole OpenHR20 to RFM69 to reduce power cons…
-
Needs an additional pin, maybe some pull-up/down - unclear...
-
I made some test with two very short programs (based on your examples!) on the feather... the dont have the same ENCRYPTION KEY but the receiver is still getting frequently messages from `rf69_manage…
-
I followed the instructions including rpi-source.
Make fails early when it compiles rfm12b.c. Details below.
Any idea??
```
$ make
make -C /lib/modules/4.19.118+/build M=/opt/public/rfm69/rfm1…
-
I think a relatively simple, and nice addition would be the ability for this library to handle multiple instances with multiple radios.
I think the changes would be relatively simple, currently th…