-
Hi i have tried the command at rs232 I didn't got a response from the bike but since then the bike turns on without the key on and close in a minute. In the time that is on the engine temp is 0 and i …
-
## Component list
- Motor.
- LM35 Temperature Sensor.
- HY-SRF05 Ultrasonic Sensor.
- 3 buttons.
- Red LED.
- USB to RS232 converter.
- Resistor 1K Ohm.
## Schematic
![PepsiCity_Scheme]…
-
You also got the rs232 connector in your mower?
Can u help with the pinout for rx tx and gnd pinout?
Thanks
-
I'm planning to connect Arduino to CTRL port of Z CAM E2-F6 in Pelco-D mode to process pelco commands from ZCAM, unfortunately I couldn't find any documentation on CTRL in Pelco-D mode.
Does it work…
-
I installed this on my HAOS install via HACS, and when I "ADD INTEGRATION" and choose NAD, and select my serial port and "SUBMIT", it just says "Unknown error occurred".
I tried every serial port o…
-
Hi, i m working on the same thing too, do you have the pinout for rj22 to db9 ?
-
What kind of circuit do you on your RS232 cable?
I tried this one but I couldn't get it to work.
-
-
-
* Subject: Sendeprobleme RS232
* Wiki-Page: Bauanleitung
* From: dripphone
* Date: Fri, 26 Sep 2014 10:56:06 UT
* Message-ID:
Hallo,
ich habe nun den Adapter laut Schaltplan gebaut. Einziger Unter…