-
hi,
I use the same Adafruit ESP32-S2 board, connected it with Tasmota (13.2.0) ESP32S1 (1), but GPIO 22 is not in the list of Tasmota as you described (
set the SDA pin to 22, and SCL to 19).
I u…
-
Sensor SenseAir S8
Firmware 4.0.2 DIYRuZ_AirSense_Router_CC2591.hex
Firmware build date 18/01/2021 11:23
Firmware version 18/01/2021 11:23
Sensor works without any noticeable problems…
-
### The problem
When using a D1 Mini based on ESP8266 with a PMS5003 and ssd1306_i2c OLED, the default settings for the logger and update_interval causes the device to reboot frequently, typically …
-
### The problem
Ive seen some strange behavior while calibrating this sensor in esphome. Every time when I calibrate the sensor the sensor gets less sensitive. When doing a hardware calibration by …
-
Hi,
Since the update my AG Pro (sht30) keeps resetting every ~2 minutes with the ESPHome logs being:
```
...
[23:12:17][D][pmsx003:234]: Got PM1.0 Concentration: 8 µg/m^3, PM2.5 Concentration …
-
-
Hello,
I went through the site, and have the following questions:
1. Are the Sensirion SCD30 and Senseair S8 sensors supported at this point?
2. I have no need for a temperature sensor: Can it …
-
@kirovilya Any chance you be willing to add support for any more popular environmental sensors?
I guess that the most popular in demand in this specific case would be the sensors that ITead alread…
-
Hi,
Thank you for your library, it is very good, and is much more flexible than my homemade solution.
I was wondering things
I have several ESP modules that do (again with my update code) automat…
-
### The problem
Similar to [#1899](https://github.com/esphome/issues/issues/1899) if the Senseair S8 reports a number less than 0, instead of a negative number, it jumps up to something like 65535
…