-
as sht10 is a 14 bit device and arduino is 10 bit , i can't integrate both
-
I am new to this so I am not sure sure exactly what is going wrong but when I try to install this I get errors it is a huge list that I tried to skim and figure out what problem I was getting but it c…
-
See implementation of TempHumiditySensor::isOk()
We need to reliably determine if the SHT15 sensor is present.
-
Hello everyone @majenkotech @diegogmx @majenkotech,@all I am trying to read data from a Campbell Scientific sensor by sdi12 with an ESP32, but the sensor does not recognize me or it simply does not d…
-
calibrate temp sensors, or at a minimum, get them consistent across the entire system.
-
Como busco código para poder programar por ejemplo el detector de humedad
-
Hello, and thank you for your contribution. I have used your library in a project to get values from an SHT75, attached on a NodeMCU, and upload them on Ubidots. It seems that the temperature and humi…
-
The Dallas plugins were reported to no longer work since ESP32 SDK 2.0.3. (see: https://github.com/letscontrolit/ESPEasy/pull/4164 )
Apparently the time needed to switch pin mode now takes 16 usec in…
TD-er updated
2 years ago
-
I have constantly different reading figures, on the sensors side I have used typ 3.3v to SHT15 sensors.
on USB5v. The reading seems always 3-4 degrees higher. (tested on many machines).
While on t…
-
Hello folks,
the tempered package I installed actually is functioning because I could do all utils and examples code for this one, all work.
http://goods.ruten.com.tw/item/show?21439300929462
But I…