-
Easier installation (via url) + better menu + lots of clock speeds (32/16/8/4/2/1Mhz) + automatic clock prescaler selection (no need for `clock_prescale_set` ).
https://raw.githubusercontent.com/db…
-
I assembled the standard circuit, the same as the project (ILI9341 + ESP32WROOM32 + Si4735), however the display is not in the correct rotation, both vertically and horizontally it does not draw all t…
-
Hello,
i try to verify code form here https://github.com/pe0mgb/SI4735-Radio-ESP32-Touchscreen-Arduino
doit devkit v1 with tft 240x320 2.8" SPI TFT LCD Touch Panel Serial Port Module With PBC ILI93…
-
Hello,
I wonder if there is any support for the V2 version of the 4.2inch e-Paper Module (B) and samples for PicoPi?
Many thanks
-
Reading a variable capacitor and controlling the receive frequency can be added to the main loop alongside the debug interface.
A global variable for new modes should be set and cleared with comman…
-
This is stated in v 3.3 release notes
-
the bar slider changes but display brightness does not.
-
Not only that it defaults to the hardware modified version, most people like me took time to figure this out. 2nd where are the hardware things I need to do to use the improved option?
-
I realized that the volume, even if set to zero, does not go down completely and in MW the noise is very high and covers weak signals.
-
I'm using an ATS-25 running 3.4
When in SSB and I manually turn AGC off when you tune so far (like 15KHz) you'll hear a chuff sound and the AGC will be enabled but the button isn't highlighted like…