-
Suggest you consider running a new crowdfunding campaign on Kickstarter or IndieGoGo for next-generation WiCAN hardware?
Related to the existing WiCAN next-gen (i.e. version 2) hardware discussion …
-
Hello,
I am testing the lilygo board outside since a few days. There is a lot of humidity outside, the lilygo is in a waterproof box (but the box has a hole for the wires on the side, so the air ca…
-
Hi Lewis,
when comparing the LilyGo SIM7080G board with the SIM800L, I observed the charging / repowering of SIM7080G is proceeding differently when the 18650 battery is discharged completely and t…
-
[x] I have read the Troubleshooting section of the ReadMe
## What type of issues is this?
[ ] Request to support a new module
[ ] Bug or problem compiling the library
[ ] Bug or issu…
-
[x] I have read the Troubleshooting section of the ReadMe
## What type of issues is this?
[x] Request to support a new module
[ ] Bug or problem compiling the library
[ ] Bug or issue with…
EnumC updated
5 months ago
-
Hi Lewis,
is there any interference going on, in terms of enabling flash encryption and AXP2101 functionality?
I have activated FE on the SIM7080G. Before that step, the script was running great…
-
Hi,
Under 3 Tips, it is stated that "⚠ SIM7080G cannot connect to cellular network and GPS positioning at the same time".
Is there a code example where it is shown best practice for switching betw…
-
Hi, I'm testing the UART communication between this device and an arduino, but I can't get it to work.
On the pin diagram it says TXD and RXD are numbers 43 and 44. but I can't get it to work, can …
-
Hi. I am trying to run an MQTT script on one core, and read data from another i2c device on the other core, using freertos to do so.
When I try to do this, I get 'failed to initialize power' from …
-
What about your measurement?
It is very high.
At switch-on (PMU is still off) the current drawn is already 240uA.
Pressing button PWRKEY to start my ESP32s3 firmware, which simply goes into deep …