-
Hi,
Would it be possible to add support for accessing saved logs from the SD card over the serial connection (so the device doesn't need to be turned off and the SD card manually removed)? It would b…
-
### Description of defect
I understand that BLE is currently under development. I couldn't figure out what the current state is so I thought I would open this issue.
I am able to build and flash…
-
Using Linux.
Artemis SVL Bootloader
phase: setup
cleared startup blip
/dev/ttyUSB0 is currently open. Please close any other terminal programs that may be using /dev/ttyUSB0 and try again.
Ske…
-
When I updated to the new 2.1.1 core software for SparkFun's Artemis Apollo3 boards, it broke FastLED support. Now I get the error "Unrecognised APOLLO3 board" when I try to compile.
I'm guessing …
-
I *think* the Artemis RedBoard Nano should be very easy to use with a LiPo battery + solar panel (6V max) in cases the deployment takes place in an area with lots of sun. I asked on SF GH repo, crossi…
-
- [ ] Correct space between pins for RockBlock
- [ ] More parallel battery-terminals
- [ ] Use ambiq module
- [ ] transistor for toggling GPS power (@zerblatt007 ) (#1 )
- [ ] usb to serial for am…
-
Using the sparkfun HM01B0 library with the Micromod Artemis Processor board on a Machine Learning Micromod carrier board.
When the Example1_StopMotion example is used, it fails to compile stating:
"…
-
From @PaulZC in #13:
> The SARA-R5 does need the PDP / PSD stuff to set up its data connection... I'm fine with you creating a SARA-specific examples folder and copying in a subset of the examples …
-
Apollo3Blue (AMA3B2KK) had doubled RAM and flash, the else are all the same. And it's hard to buy 3b today, 3b+ is cheaper and easier to find purchase.
Will the SVL work on 3b+? or how can I adapt …
-
When looking at Sparkfun's documentation on the Artemis for information about the max source/sink current of the Artemis, I noticed that some of the Pads support a connection to a high (pads 3, 36) or…