-
Hi all,
I recently connected the fuel pump and thermofan to the speeduino board V0.4.2.
I tried to load the Dec16.zip firmware from the www.speeduino.com web page (outdated/different) and found t…
-
Decoder for Early Jeeps some volvos and renaluts with Renix MPFI.
This trigger mode came in a four cylinder variation which used 44 base teeth with two gaps 180
degrees apart, and a six cylinder ve…
-
Hello,
I am working with a 2.1 Board for M50b25tu
I am having no start issue with no RPM values on Tach or in Tunerstudio.
I am getting 5 Volts at 1 and 2 pins on the crank plug(from the ECU) and…
-
Dear Gentlemen,
I have been struggling with the trigger pattern for dual wheel cam 24 tooth primary wheel (12 at crank speed) and 1 tooth wheel also at cam speed. The car is a toyota ke70 with a 4a…
-
I've been thinking for a while about e-throttle support.
Seems we have everything ready for that:
1)throttle body TPS sensor reading - already done.
2)Pedal sensor - easily doable - speeduino is …
-
Hello,
I am a speeduino enthusiast and I was wondering if the current models have **OTA firmware updates**?
Thanks in advance.
-
In basic distributor mode + single coil output, for 1, 2, 5 cyl, there is a OK spark in synchro with the trigger event (equivalent to breaker point lobe), but one extra spark KO in the middle between …
-
Hi!
Im running efi core4 from pazi88 github with no issues on firmware 202305
i updated to latest firmware and im having some problems
VVT1 sensor dont read any value, and no duty aplied to solenoi…
-
First as you will see in the youtube video, whatever I change pin assignment for VVT then WMI will change automatically. In the opposite direction as well. I found that this also takes place if workin…
-
I'm developing my own incar controller, which need to have two-way communication with Speeduino.
I've tried to opimize my controllers timing to have the least stress on Speeduino, which tries to r…