-
Hello.
I'm making an OAT.
The firmware is up to date on the MKS Gen L V2.1 board.
I'm going to use the motor as the Close loop motor I had.
It works with the same input as A4988.
So I tested it, …
-
## Introduction
Zephyr at present does not have a provision to control stepper motors. **Stepper Motor Controllers** do have a set of common functions which can be bundled together in a API as pres…
-
I have a doubt about the stepper motor driver code sir. Could you please send me your email id. My email id is jagadeeshbalaji21@gmail.com
-
Is there a way to switch off all fans in standby mode / after printing? I still have fans running in standby mode, but I don't know if it's the motherboard fan or the power supply fan. But when I do a…
-
Tried to use this with LDO 2504AH on Octopus v1.1 with TMC2209(s) and senseless homing doesn't appear to be working even with a value of 255 the X Axis is crashing into the gantry.
I add `2504ah` t…
-
Is this suport 4 corner actuactor, withsurge and 2 TL rear and front?
I want to used simhub motion.
And it suport step/dir??
Iam planing to try first with stepper motor. Bacause iam project make…
-
Hey Mike,
Thanks for all the hard work! I have been planning on building a jukebox for a while, and have an idea of running a DC or stepper motor with an actual spinning record while a song is play…
-
i just stumbled on the new *Stepper-Motor* Mode options - and then found that these are currently only available when you manually install the library (download, unzip, move to arduino library folder.…
-
Hello,
I am attempting to get a stepper motor to spin, but cannot confirm values returning from the slave using the defined PDO mapping.
Application is running on Windows 11.
I tried controlling …
-
Got sensorless homing working fine with FYSETC TMC2240 and the following config:
[tmc2240 stepper_x]
spi_software_mosi_pin: PB15
spi_software_miso_pin: PB14
spi_software_sclk_pin: PB13
cs_pin: P…