-
Shelly Plus Plug S has four WS2812 LEDs in the outer ring.
This template for both LED Strings (each with two WS2812) on GPIO 25 (left half) and 26 Right half) works for me:
` {"NAME":"Shelly Plus Pl…
-
Hi,
As of Version 11.1.0 of Tasmota Shelly 3EM is fully supported (Firmware has to be compiled manually), so I decided to convert the last one of my Shelly Devices to Tasmota. All my other Shelly D…
-
Thank you very much for this excellent project. I was finally able to use ST to trigger my Gosund Sw6 Tasmota flashed 3-way switch to toggle power properly with a get command like this http://192.168.…
-
It would be awesome if support could be added for the new Shelly Plus 1. The tasmota info is located here https://templates.blakadder.com/shelly_plus_1.html
-
**Describe the solution you'd like**
```yaml
fan:
# other stuff
availability_sensor: sensor.ir_bridge_status
```
OR
```yaml
fan:
# other stuff
availability_template: "{{ is_state…
-
Hi,
i'm using your plugin for a plug flashed with tasmota firmware.
The plug with power meter and LED function is an AVATTO OT08.
https://templates.blakadder.com/avatto_OT08.html
The template is…
-
Is the Temperature Sensor AddOn for Shelly 1/1PM supported?
-
Hello,
The cover-time-based component works great to control my rollers/shutters (they are now connected to modbus I/O, one output for open, one output for close).
I've also tested this with Son…
-
Ciao! Sorry for my english, I use google translator:
I have a Sonoff mini R2 with firmware 3.7.6, I tried OTA mode without success, I see it in my internet network with IP address, I use rester with …
-
Hi Brett
I followed your steps down to the T. I even read through a few issues that have been reported that appeared to be similar.
I'm sadly not getting the Child Device spawn after creating a …