-
# GUIDE:
1. You CAN NOT mix PT100/PT1000 and thermocouples:
If you have only one hotend then you can have the following:
- Thermistor (that is an ADC Temp Sensor [uses a pure analog I/O pin]…
-
Sapphire PRO shows ERR7 and stops printing. I hapens on every print after an hour or more. Anyone having the same expirience.
-
### Objective:
Add a number of sensors to my BBQ and the smoker I don't yet own. Bluetooth temperature probes are not cheap and relatively useless still as all you will get is a notification on your …
-
The TLC27L2CD has an iput offset of max. 10mV. For example the voltage at the thermocouple pins at 245°C is approx. 10mV! This could be somehow compensated by the calibration potentiometers but it is …
STB3 updated
3 months ago
-
Can anyone help me figure out why my EBB2240 is displaying -93 degrees for my Hotend temp? Im using a Rapido hotend and i think its Pt1000. I have tried using these settings
sensor_type:MAX31865
…
-
I'm having issue working this configuration
`#define SERIAL_PORT -1
#define SERIAL_PORT_2 1`
I'm using this guide to connect MAX31865 in software SPI configuration:
[https://drive.google.com/fil…
-
Hello,
I understand this might not be the right place for my question, and my question may not be even related to the firmware. But I have a project where I would like to install the innards of the T…
-
If you want, you can try to figure it out and modify it to suit your needs.
Project -> [description page](https://en.gradient-sg.com/t962/#downloads) -> [App](https://github.com/sevstels/T962-PC)
-
Hi I just performed the mod on a t962-a with an Lpc2134 and socketed thermocouples. I’m running 0.5.2. I have a couple of issues.
My ds18b20 appears to register too hot so I tested it with ice …
-
This seems strange to me. Doing some continuity testing, if I remove the neopixel power jumper the left two pins (NPWR to on-board 5V) are still electrically connected. As shipped the jumper is instal…