-
# Summary
I have been on the setup.py then setup.cfg bangwagon for about ten years, but am begrudgingly moving over to pyproject.toml. There is an extremely brief mention of this on the docs site,…
-
**Describe the bug**
Build failure caused by C++20 compiler change: template-id not allowed for constructor in C++20
**To Reproduce**
Steps to reproduce the behavior:
1. Download git repo on Fed…
-
The build fails for several standalone modules with a compiler error.
This is on Arch Linux on x86_64.
The AUR package uses the following `make` invocation pattern to build the standalone module…
archi updated
1 month ago
-
-
## Method of Mitigating Polabs with Optimized Films
1. Introduction: Polarization aberrations limit HCI
2. PRT + Multilayer Thinfilms with Poke
- Review PRT, Polarization Aberrations, the Jones…
-
I'm struggling to set it up :/
I am using a raspberry pi 4 with the PN532 NFC module with GPIO:
GND -> 6
VCC -> 4
SDA -> 3
SCL -> 5
I have followed your steps, but when I run `python3 main.p…
-
Recently was introduced to the `@classmethod` way of constructing the raybundle. Think it might be nice to do so I have alternate ways of constructing the raybundle based on whether polarization ray t…
-
This is one of the few pieces that we are still pulling from the genx file. It would be good to figure out how to compute it from "first principles."
-
Hello! I'm currently working on a project to do some thin film optimization and wrote my own implementations of the BYU and Macleod multilayer matrix method for computing the effective fresnel coeffic…
-
M1 mac can not compile when make -j.
ld: symbol(s) not found for architecture arm64
clang: error: linker command failed with exit code 1 (use -v to see invocation)
Intel works