-
In the corrected (sic) image for the beta kit hardware round 1 PCB silkscreen: There are two negative (-) pins and no positive (+)
![image](https://cloud.githubusercontent.com/assets/4117408/8594611/c…
-
List of stuff to fix in the 8mm feeder:
- [ ] Make tape width closer to 8mm (say, 8.5mm)
- [ ] Start / End / Middle Position Marks (See below)
**Start / End / Middle Position Marks:**
Idea from @von…
-
Affects the ELED01 and ELED02 PCB's. Could use suggestions from beta kit users that have resistors on-hand to try different values that don't exceed the specs below. We would like to know what light…
-
# Release Plan
## Release 1
- [x] Four axes
- [x] One nozzle
- [x] Camera doesn't move in Z
- [x] Definable Gcode
- [x] Variables in Gcode
- [x] Sub-Drivers
- [x] Simple Actuator support (one …
-
This issue covers all problems that have been/will be discovered with the new heated bed and top panels. @FlyingLotus1983
Power Plug cutout too large.
Jigs for mass production
Corners prevent prope…
-
- TubeFeeder should allow actuator choice. Preferably with a way to set G-code for this actuator.
- Actuator should be set on for a given time. This could be before or after the part is picked up. per…
-
Please see:
- https://github.com/TinWhiskers/fpd-design/wiki/EFD01---Feeder-PCB---Carousel/
-
Cri-S has pointed out that red light works well on green solder mask if you only look at the blue channel. We should, however verify this and compare it to what we're currently doing. This will driv…
-
Need to write a calibration procedure for the beta testers, that instructs them on how to get their machine to place accurately.
Will need some input from Jason on this.
-
NOTE: The heated bed and up-looking camera boards have been combined into a single board that does both functions.
Please also see:
- https://github.com/TinWhiskers/fpd-design/wiki/ECAM03---Up-Look…