-
Hello,
I tried several examples and different parameters on the examples provided, and none of them allowed me to reach the 1/3 of the motor speed.
At this time, I'm running the driver TMC5161 f…
-
Hi.
First of all I apologize for my level of English, I probably have more than one fault.
Once the code "StallGuard_TMC2209: https://github.com/teemuatlut/TMCStepper/tree/master/examples/StallG…
-
### Description
It would be good to have CHOPPER_09STEP_12V similar to CHOPPER_09STEP_24V.
I'm looked for some documentation on how to define properly CHOPPER_TIMINGs for 0.9 degree motors running…
-
Hello ZoetropeLabs,
I tried using this library with my as5048a, and normally if anything doesn't work properly I would assume it was my mistake at some point. However, I tried the same connection w…
-
Hello , did somebody tried to use this library as motion controller mode.
Meaning that sending speed and destination via SPI and chip has full control motor ?
thanks a lot.
-
Ive got a strange issue with a new printer im settting up. i have a set of tmc2209's, on a 24v corexy.
the original 1.8* motors are louder than they should be, but i didnt think much of it. this w…
-
I got my board today. For testing, i connected one stepper (Z). According to the manual i removed all jumpers from the STEP/DIR headers and set them on the UART headers. But i always get a "TMC CONNEC…
-
Documenting here for others to see.
There seems to be some connection issues with TMC2208 with at least AVR and DUE platforms.
The likely commit to cause the issues is d27257900a14ee8cd8df7d5c9b01…
-
I know this is kind of basic, but I'm trying to understand how to wire up the uC and stepper driver.
**tl;dr:** Does anyone have a basic wiring diagram for ESP32->TMC2208? I haven't been able to ge…
-
environment:
- TwoTrees Sapphire Plus printer
- MKS Robin Nano 1.2 board
- 3x2208 (X,Y,Extruder) + 2x2225(Z, Z1) TMC Stepper drivers - using 2208 for 2225 as per comments
Configured in Printer…