-
Dear everyone,
I was wondering how to use any UART of the ASUS Tinker V board.
Any UART (e.g. UART4 at PIN 6 and 8 of the 20-pin GPIO header) but the one connected to USB would be fine.
Is there an…
-
**Describe the bug**
ESP32S3 crashes when sending image over UDP, but the ESP32C3 works well.
**To Reproduce**
add the following lines to `samples/subsys/mgmt/mcumgr/smp_svr/prj.conf` to be able …
-
- sRST引脚在上电的时候会先给出5V再降到3.3v的问题
- 偶尔上电时sRST是LOW的状态导致target无法运行
- 在USB接触不良的情况下 USB CDC 容易接收不到 UART 数据(群里有人提过,说是COM未打开的时候target持续发送数据然后再打开就无法收发数据了,实际测试不会,但是USB接触不良确实会)
-
Hi,
I lost the encryption key for esphome when I lost the previous HA config. The droplet gets reconized on the new install but I can't give it access to integrate without this key so I'm trying to…
-
#### What I want to see in the next version of Omega
It would be nice to be able to change between the internal uart and usb port uart in order to interface external electronics.
Also an app (& py…
-
- On MiSTer. Can replicate (so far) with NES and PSX core.
- Can replicate by just using `load_core .../NES.rbf > /dev/MiSTer_cmd`
- Reader immediately reconnects for me, does not for other report, …
-
I have a Waveshare Industrial USB to RS485 Converter which is on ttyUSB0 on my Pi5
I have got it working in Windows with some software called ModbusPoll and can read from my Sunsynk inverter.
I …
-
Is there any way to do so?
I'm able to change baudrate in the source code.
And say communication program to set specific baudrate (picocom).
But it seems 115200 is the only working setup.
It's…
-
Hi everyone,
I don't know where i can answer my question because there is no discussion section.
I looking to establish wifi comunication between two esp32's, one connected to a PC to the software a…
-
2.7 test case:
```Java
public static void main(String... args) {
SerialPort[] commPorts = SerialPort.getCommPorts();
System.out.println(commPorts.length + " comports found.");
for (Ser…