-
How can I configure these parameters in the firmware?
Thanks.
-
I've been trying to install KubeSphere on existed kubernetes.
My Kubernetes information below:
- kubernetes version: v1.22.8
- Container Runtime: CRI-O
- Cluster Environment: Bare-Metal (3Master…
-
I have recently purchased a board on Ali and uploading your firmware produced a randomly garbled display.
I turns out that my board has a common anode (CA) LED display (p.n. **TUSO-02803-U**) as op…
-
### Description
Hello
I'm running a TPU v3-8 VM on Google. On the VM I installed jax with `pip install "jax[tpu]==0.2.16" -f https://storage.googleapis.com/jax-releases/libtpu_releases.html`.
U…
-
-
The current stable release 2605.9.0 has broken all our clusters (AWS / GCP / Bare metal + dev / prod). The issue we observe is that some nodes become `NotReady` after a while and traffic going to cont…
-
Hello guys,
more than one time i tought to experiment some customization on the firmware, but i sincerely don't know where to start. I can write some basics in arduino, i'm not an expert, but it's ok…
gisep updated
4 years ago
-
Moisture is a necessity in any ventilation system, because it is important that the lung tissue is not dried out. This issue is usually handled by hardware in the system that adds moisture, or special…
-
Hello,
I'm prototyping around the low cost 8 pins stm8s001 / stm8l001
I'm using a stm8s103 board definition in arduino, since it's the same family.
This chip is different than the other ones in…
-
My CO2 Laser Power Supply have these connections:
H: Laser output control (high level effective)
L: Laser output control (low level effective)
P: Water protectio switch (valid if grouded)
G: Gro…