-
```
What steps will reproduce the problem?
connecting the CANdiy shield and the can cable.
then use the serial monitor.
What is the expected output? What do you see instead?
the error i get is:
FF
!!…
-
Ctrl Alt Right switches 2 tabs for me. If I hold it for a few seconds the IDE switches like crazy. Afterwards I cannot type anything in the text editor again. Compiling also doesnt work.
I also was c…
-
```
What steps will reproduce the problem?
connecting the CANdiy shield and the can cable.
then use the serial monitor.
What is the expected output? What do you see instead?
the error i get is:
FF
!!…
-
```
What steps will reproduce the problem?
connecting the CANdiy shield and the can cable.
then use the serial monitor.
What is the expected output? What do you see instead?
the error i get is:
FF
!!…
-
Hi @bee-mois,
hier im Repository wurde quer durch die Bank die PlatformIO Konfiguration aktualisiert, auch bei Deiner Firmware, auf recht neue Versionen, vermutlich weil ich keine Informationen dar…
-
I understand from the link below that the TMC2130 in SPI mode can be run purely over the SPI bus with no need for any connections to the step and direction pins. Can I do this using this library?
…
-
```
What steps will reproduce the problem?
connecting the CANdiy shield and the can cable.
then use the serial monitor.
What is the expected output? What do you see instead?
the error i get is:
FF
!!…
-
Hello. I have the problem to probably connect to the uart of the TMC 2209. I have some experiences with Arduino and stepper drivers, but not that much to be able to figure out what my issue is. I used…
-
Hi Watterott folks,
why is there SPI1.h and SPI1.cpp implementing new classes SPI1Class and SPI1Settings, and then one new extern instance SPI1?
Why not rather redesigned SPI.h and SPI.cpp imple…
-