-
First thanks for sharing this code! Can't wait to get it working on my system.
Some suggestions: regarding the main.c
#define CONFIG_CALLSIGN "R2BDY"
#define CONFIG_LOCATOR4 "KO85"
1) Is it an …
-
I am trying to transmit on 20M and running a Pi-3-B+, but this problem also happens on a 3-B or a Zero-W. The program never crashes, but the PTT or transmit signal coming from the Pi stops somewhere b…
-
This is just a comment not a bur report.
If I read the SI5351 datasheet correctly you do not need to use si5351.set_correction(0,SI5351) during setup as it will remember the last setting.
BTW…
-
You need to disable CLK0 from the si5351 during setup. Otherwise the circuit transmits a carrier @ ~14.192.00 while waiting for the GPS to lock.
ie simply change
si5351.output_enable(SI…
-
This is not really an issue more a question. Before trying this software, are there any informations about the mWatts that falls out of the PI? There was mentioned a simple transistor amplifier. Is t…
-
Crashes when I try to start wspr on a raspberry pi 1. The only way to recover is unplugg the device and plug it back in.
-
//////
If you using the Raspberry Pi Zero W and have the same issue, as far as i know there is no direct solution atm. Even not with an older Raspbian Build. So if you are only here to fix this probl…
-
Hi,
first, thanks for this great work!
I have a pico with wifi and can be great to have a fully standalone version without any additional GPS module/antenna. Is it feasible?
-
First of all thank you very much for this wonderful piece of software!
Is there any chance you are planning to develop this also into a stationary beacon with the option to disable tracking and to c…
-
it would be nice to have a good/automatic test procedure to create a plot as in for steve-m#10
the patch for that was merged with PR: #66
there must be a test/detection program for detecting the f…