-
While fixing #115, it was found out that d64copy, imgcopy and d82copy write out image files that contain error codes of "0" if an error map is to be written.
The error code "0" is written if a bloc…
-
I have a problem with a physical 1581 which won't be detected and can't be addressed on the IEC bus. The drive's ROM is 312558-01 (which seems to be identical to 318045-01 as far as I was able to inve…
-
It seems like some times if d64copy encounters a sector with a missing header, it will hang indefinitely.
This is with an XUM1541 ProMicro board and transfer mode serial1 and serial2. Some times us…
ymgve updated
4 years ago
-
I recently downloaded, breadboarded and successfully got a SparkFun ProMicro clone to take the .hex file for it (after some learning on the command line) and I have a device "xum1541 floppy adapter (P…
-
`cbmformat` (and all other tested tools from opencbm) seems to work fine, but running `cbmformat` with `--verify` runs endlessly.
My setup:
opencbm 0.4.99.104 from debian 12
xum1541
1541-II with…
-
Would be nice to be able to use a real 1541 drive, through the use of a Pi1541
-
imgcopy has some serious issues:
1. the protocol s3 is not implemented in the xum1541. Thus, you should never use s3 protocol!
2. For 1581 drives, it uses original as transfer protocol, but sets w…
-
Hi Steve,
I love your product you created a few things unless I am missing something.
-Under Jaffy Dos if the Tape Port is plugged into the C64 it will pull a signal and lock up both a real 15…
-
Hi there! I recently built a XUM1541 with a 7406 and tested it with a 1581, which I also built. After some tinkering, I am able to use the drive through the XUM1541, but only after manually unsetting…
-
This is a bug report from SF (https://sourceforge.net/p/opencbm/bugs/74/):
If i list disk files using the command "cbmctrl dir 8" i obtain a file with the following name:
"a1.@@@@@@@@@@@@." and type…