-
I can't figure out why I am getting these additional z hops all the sudden. It leaves me printing in the air after a resume.
When I pause a print, toolhead moves to parked position and then hops u…
-
Chcemy wykorzystać API allegro do tworzenia linków referencyjnych z linków do produktów.
Na stronie https://allegro.pl/afiliacja/programy/allegro-affiliate/kampanie/210e1178-92bf-45cf-9bf5-f9c61e9…
-
Występuje problem:
- [X] z zasobem REST API / with a REST API resource
- [ ] ze środowiskiem produkcyjnym / with the production environment
- [ ] ze środowiskiem testowym / with the test enviro…
-
Mam problem z połączeniem się z danymi produkcyjnymi.
Na środowisku sandbox bez problemu tworzę integrację. Na prod nie mogę. Mam błąd:
`Error with Allegro`s external API: HTTP request returned…
-
Due top my Klipper setup, Z+ and Z- are inverted, on KlipperScreen it was easy to invert them by setting this in the Klipperscreen config, and also on Fluidd they work the correct way round, but …
-
When scrolling the Events page the filter bar stays on top of everything, including the header.
Made a PR adjusting the z-index to place it just below the header on the z-scale.
-
Hello!
Can you give more detailed instructions on Auto Z-Offset Calibration?
3. Run AUTO_Z_CALIBRATE (OK)
4. Move Z to 0 ( Which way? G1 Z0 or use manual z-offset adjustment from the web interf…
-
The Z-axis is unstable, and after working for a period of time, the Z-axis may sometimes lose steps and become higher or lower than before
-
If certain tools are selected (e.g. grab) then `esc` undos the last opperation, however there have been a few occasions where I mistakenly delete a part, or finalize a movement only to realize I made…
-
Generování náhledů si vzalo paměť, která pak chyběla Tomcatu. Reseni je dat Tomcatu dost pameti pri spusteni.