-
About week ago I succeed with building my first 6lowPAN sensor network. The setup is following: 6lbr, running under Ubuntu VM with cc1310 slip-radio connected to it. Output from slip-radio is followin…
-
Hi,
If I want to transfer datum between two 6LoWPAN nodes ,it seem like must have a Border router.But I donn't want to use Border router,how to set ?
thanks,
jliu
-
Hello there,
If I use 6lbr as the border router and run cetic-6lbr-client.c on my 6lowpan nodes along side of my application code which just opens up some UDP sockets and transmits periodic data, i…
-
Steps to reproduce:
1. Clone the example, switch to OoB_5.4 branch, mbed update.
2. Change settings in mbed_app.json. (enabled trace, thread config as below)
3. Update firmware of gateway with http…
-
Hi,
I have been working for some time now with 6lbr. My setup is basically a RPI2 which acts as a border router and in which 6lbr is deployed. The RPI2 has connected to one of its USB ports a CC265…
-
I am running the following setup:
- `mbed-os-client-example` running on top of _NUCLEO_F429ZI_ & _Spirit1_ Sub-GHz RF
- `k64f-border-router` adapted to run on top of another _NUCLEO_F429ZI_ & _Spiri…
betzw updated
7 years ago
-
Is this possible to support Thread instead of ND?
-
Can I use frdm-k64f + 802.15.4 shield as a gateway? It has almost the same hardware as a 6lowpan gateway from Firefly, right?
-
Does the mbed gateway support Thread commissioning?
-
Target: NCS36510
Toolchain: Any
Error:
Stack overflow. Adjusting the stack and heap sizes prints out varying debug messages but regardless of what size they get set to, it will always fail
Attem…