-
### What happened?
When controlling WLED via DMX in "Effect Segment Mode" brightness changes are too slow. In general when using DMX consoles to send brightness changes, these changes are only appl…
mxklb updated
6 months ago
-
I am using the i2s to send the dmx data to my par, and I wired the di pin to the Rx pin on my nodemcu esp8266, the gnd and re pin on the nodemcu gnd pin, and the vcc to the vv pin on my node mcu. I co…
-
Hello,
I want to use this artnet for my home automation (home assistant). I am a hardware engineer, so normally I know what I am doing. Sometimes schematics are provided and a simple example. But n…
-
I've built an ArtNet to DMX converter based on this library. At first, it seemed to work quite well, but I'm noticing short random breaks in the DMX output every few minutes (every 30s to 5m at random…
-
### Steps to reproduce:
1. create fixture
2. enable ArtNet Input in blender-dmx
3. send ArtNet Data from Light-Control
4. check if receiving
5. create volume Box
6. change renderer to cycles
…
-
Hi,
I'm writing software to run an artnet node and I did it on Windows, but i need to run it on Debian based Linux. I compiled the program for linux-arm64 in VS, but the ArtNet part doesn't work.
…
-
Receiver universes shows in DMX Workshop as DMX Inputs, but must be an DMX Output
-
**Describe the bug**
If a scene is running by a button or slider, clicking a flash button associated with the same scene makes the output device flicker. In case of a slider, the slider gets set to 0…
-
Hi,
I'm running ola 0.10.9 on a raspberry pi and I have a Eurolite DMX512-Pro connected via USB.
I deactivated all plugins except dummy, Artnet and ftdidmx
From the logs (attached) I thinkt that t…
-
After installation of the plugin and editing the configuration.yaml to
light:
- platform: artnet_led
host: 192.168.111.123
max_fps: 25 # Max 40 per second
…