-
### Describe the bug
If the mainline (non-CT) ath10k driver/firmware are used for R7800 (master snapshot with kernel 6.6), the following dump is seen in dmesg after every booting. However, WiFI w…
-
Recently, I've found that instead of formatting files, it has been replacing them with 0 byte files. Yuck! This seemed to be tied to one of the supporting modules getting updated, then it went away …
-
**Describe the bug**
Thank you for looking at this.
When making two separate streams using two different FFmpeg chains for audio processing, both streams exhibit severe jumping in the audio output…
-
On AIX 5.3, gcc 4.8.2 build failed (openssl release 3.0.8) when run gmake or make with "gcc: Arg list too long" error
...
gcc -maix64 -pthread -O -shared -static-libgcc -Wl,-G,-bsymbolic,-bnoentry…
-
### Description:
### Server Setup Information:
* Version of Rocket.Chat Server: 0.57.1 / 0.57.2
* Operating System: Debian 8
* Deployment Method(snap/docker/tar/etc): via Ansible and …
-
### Description
When liquidsoap 2.3.0 from main runs with source.say_metadata being used, we get the following mess at startup.
* the transition to safe_blank is executed
* the source.say_metadata …
-
```
var t [256]byte
func f(b *[16]byte) {
for i, v := range b {
b[i] = t[v]
}
}
```
Compiles to:
```
0x000f 00015 (tmp1.go:7) MOVBLZX (AX), DX
0x0012 00018 (tmp1.go:7) …
-
When I am trying to create a project using sane, it fails with a segmentation fault.
```
$ sane new sane-sandbox
Detected different versions for sane's locally installed ember-cli (0.2.7) and your gl…
-
Hello!
I just searched for something like fish-pepper, found you.
Sadly I am unable to get fish-pepper working, neighter in a clean Linux Mint 19 VM with npm freshly installed, nor in a node:lates…
-
I have a zyxel nr7101 router. I ran openwrt on it according to the openwrt instructions. I use qmi protocol. At higher speeds (about 200mbit/s) achieved in the lte network, the router sheds errors as …