-
If the wifi credentials are correct but the pool information is not or the pool is not available/compatible the system will continuously restart.
-
only on the input side of each voltage domain, there is another set of 3 caps connected between VDD4 and VDD
skot updated
11 months ago
-
according to the [TPS40305 datasheet](https://www.ti.com/lit/ds/symlink/tps40305.pdf?ts=1699556087481) BP is a 6.5V Output bypass for the internal regulator. We don't want to pullup the PGOOD op…
skot updated
11 months ago
-
The pins I thought were the on-die chip temp sensor don't seem to be working. the EMC2101 will read 127ºC, the max temp all the time.
It's probably best to DNP resistors R7 and R8 to disconnect the…
skot updated
11 months ago
-
On the bitaxeUltra v1 the EMC2101 FAN_SPEED signal got a 5.6k ohm pull-up in order to set the default fan speed to 100%. This works well.
For some strange reason this also inverts the PWM polar…
-
-
Some power supplies come with these 2.5mm barrel to wire screw terminal adapters:
Unfortunately they are too high resistance for use in powering the bitaxe. They will drop the input voltage too m…
-
Hi, after updating via the web interface from 2.0.4 to 2.0.5 I have a lower hashrate. I didn't change anything in the settings 575/1200. Model: | BM1366
Thanks
-
I am connected to my WiFi but I don't seem to be mining. How do I debug? I am using a Bitaxe board purchased from D-Central. I am trying to connect to public-pool.io
Also, my led displays ASIC model…
-
Most 5v power supplies available come with a 2.1ID 5.5OD barrel connector. This will reduce the amount of work to get a bitaxe working and provide a little protection against shorting.
When creatin…